A/C REPAIR CYPRESS TEXAS EVAPORATOR COIL REFRIGERANT LEAKS

This year 2017 in Cypress, TX. we are finding an alarming number of Evaporator coil Refrigerant leaks. It is a must that these replacement coils get installed correctly. A lot of the manufactures have gone from copper to aluminum and not supplying the metering device. Also, 410A refrigerants fractionate, requiring new refrigerant. Texasstarhvacr.com

 

Gas leaks in Cypress Texas

During our service calls in Cypress Texas we have been finding an amazing amount of gas leaks in new homes and existing furnace change outs. We would recommend from time to time to go into your attic and check for gas leaks, which smells like rotten eggs. Have your furnace serviced at least once a year by a competent service technician.IMG_1362

MEASURING ACTUAL SUPERHEAT AND SUBCOOLING

What is Superheat ?

Superheat is the difference between the actual temperature of the refrigerant gas as it leaves the evaporator and the boiling point temperature of the refrigerant in the evaporator coil. After boiling, the refrigerant continues to warm up. The number of degrees it “warmed up” after boiling is called the superheat. Under worse case conditions¬†(low load or **¬†orifice systems), the refrigerant in the evaporator boils off near the end of the evaporator coil. To make sure the liquid does not enter the compressor under the worse case condition (low load), the refrigerant manufactures of air conditioning equipment, publish charts indicating what superheat should be, at a given indoor wet bulb measurement and an outdoor air temperature. Superheat is your best indication on a fixed orifice system of the proper refrigerant charge. If everything else is working properly and the actual superheat is too high, add refrigerant. If it is too low, remove refrigerant. ** Orifice is a refrigerant metering device. Sometimes called a piston.**

What Is Sub-cooling ?

Sub-cooling is the difference between the boiling point of the refrigerant and the condenser, and the actual temperature of the refrigerant as it leaves the condenser. The degrees that the refrigerant cools down below the boiling point is the sub-cooling. Under worse case scenario (Low Load For Thermostatic Expansion Valve). The sub-cooling will continue to rise. If the sub-cooling rises too high, liquid may be backed into the compressor causing damage. On a thermostatic expansion valve system sub-cooling is the best indication of the state of charge in the refrigeration system, since these systems are designed to maintain constant superheat. Proper charging a system insures maximum efficiency and longer equipment life.

**Note** Proper airflow must be checked before superheat and sub-cooling.